Attempting to extrude with no tool selected

[Mack]

I'm getting an error on trying to extrude for the first time. "Attempting to extrude with no tool selected"
I checked the config file; M563 looks to be set properly. Any thoughts? I tested my wiring with a continuity tester; everything looks good there.

[Alexander Mundy]

The pics you posted on FB showed you defined tool 0 but it apparently isn't selected.

T0 is the gcode to select tool 0.

[UltiBots]

This is the first report of such behavior. Maybe another kit owner has seen this. We haven't. Please search/post @ https://www.duet3d.com/forum/index.php for clues. Keep us posted - Brad

[Alexander Mundy]

I remember an older firmware did not have the tool selected by default and you had to put T0 to select it in the config after you defined it so I still do anyway. Don't know if that is the case here or not. @Mack what firmware version do you have?

[Alexander Mundy]

Yes, my last post was in June but it's showing as today