Hey guys, I'm having a little trouble with the aero titan
So I get it to extrude fine from machine control but afterwhile into print it starts shredding filament, and subsequently I find a clog in the nozzle.
I did tighten the nozzle at 250°C. Tried messing with the knob, as I move it I start to hear the backlash from the large and smaller gear.
Also, thank you for taking the time to read this.
Settings:
Retraction is set to .5 mm (tried 1/1.2/1.5)
Temp: 205/200 (tried 200/195 & 200/190)
Bed: 55/50
(temps are "first layer" / "subsequent layers")
aero titan clogging
Return to “D300VS-PLUS Upgrade”
Jump to
- UltiBots General
- ↳ Announcements
- ↳ General Discussion
- ↳ Issues & Requests
- D300VS-PLUS Build Support
- ↳ Frame Assembly
- ↳ Belts & Pulleys
- ↳ Motors
- ↳ Electronics Wiring
- ↳ Extruder Assembly
- ↳ Ball Cup Arms
- ↳ Calibration
- D300VS Build Support
- ↳ Frame Assembly
- ↳ Belts & Pulleys
- ↳ Motors
- ↳ Electronics Wiring
- ↳ Micro Extruder Assembly
- ↳ MagBall Arms
- ↳ Calibration
- 3D Printer Kits
- ↳ D300VS
- ↳ K250VS
- ↳ MKVS
- ↳ UltiMax & MendelMax
- ↳ D300VS-PLUS
- Printing
- ↳ First Print(s)
- ↳ Cooling
- ↳ Nozzle/Bed Temps
- ↳ Filament
- ↳ Adhesion Surfaces
- ↳ Print Defects
- Mods & Upgrades
- ↳ Enclosure Designs...
- ↳ UMBEE
- ↳ Dual Extruder
- ↳ Arms...
- ↳ D300VS-PLUS Upgrade
- Software
- ↳ Slicers
- ↳ Hosts
- ↳ PC Drivers
- ↳ GCODE
- Electronics
- ↳ Duet Wifi & Ethernet
- ↳ Azteeg X5 Mini
- ↳ FSRs & JohnSL Board
- ↳ Power Supply
- Hot Ends & Extruders
- ↳ E3D V6
- ↳ Titan Aero
- Firmware
- ↳ RepRapFirmware
- ↳ Smoothieware
- ↳ Marlin
- ↳ Repetier
- Heat Bed
- ↳ Borosilicate
- ↳ Kapton Heaters
- ↳ Heat Spreader
- ↳ Print Surfaces
- For Sale & Trade
- Staff
- ↳ Issues / Discussions
- ↳ Spam