aero titan clogging

Post Reply
snomon
Posts: 28
Joined: Fri Sep 08, 2017 5:04 am

aero titan clogging

Post by snomon » Tue Oct 31, 2017 6:30 pm

Hey guys, I'm having a little trouble with the aero titan
So I get it to extrude fine from machine control but afterwhile into print it starts shredding filament, and subsequently I find a clog in the nozzle.
I did tighten the nozzle at 250°C. Tried messing with the knob, as I move it I start to hear the backlash from the large and smaller gear.
Also, thank you for taking the time to read this.

Settings:
Retraction is set to .5 mm (tried 1/1.2/1.5)
Temp: 205/200 (tried 200/195 & 200/190)
Bed: 55/50
(temps are "first layer" / "subsequent layers")

Post Reply