Search found 9 matches

by becega
Mon Apr 09, 2018 10:54 pm
Forum: Titan Aero
Topic: Titan Aero Air flow
Replies: 2
Views: 1385

Re: Titan Aero Air flow

Thanks Brad, that is how its working on mine. And it looks to be printing fine. Just wanted to double check
by becega
Mon Apr 09, 2018 7:26 pm
Forum: Titan Aero
Topic: Titan Aero Air flow
Replies: 2
Views: 1385

Titan Aero Air flow

Should the Fan in the Aero be pulling air or pushing the air to the heatsink?
Thanks
Benjamin
by becega
Sun Jun 04, 2017 2:37 pm
Forum: E3D V6
Topic: Extruder Clogged
Replies: 4
Views: 983

Re: Extruder Clogged

FIxed if by pushing it with a metal wire from the button and removing the idler so the clog had an escape. I considered turning off the fan , but the filament that clogged it required 235 so it could affect the other pieces.
Thanks
by becega
Wed May 31, 2017 5:15 pm
Forum: E3D V6
Topic: Extruder Clogged
Replies: 4
Views: 983

Extruder Clogged

I was having to much stringing issues with a new filament, and I think, i went to high on the retraction 4mm, and now the hotend is clogged, when trying to feed filament it just grinds. What is the best Way to deal with this? Tried increasing temperature and passing new filament. I also removed the ...
by becega
Mon May 15, 2017 8:29 pm
Forum: Adhesion Surfaces
Topic: PEI and TPU?
Replies: 3
Views: 658

Re: PEI and TPU?

Thanks, right now with just the glass TPU has no problem sticking at all. Even with PLA if the prints are small they stick fine, but taller prints are getting loose. Blue tape has been working great for that, that is why I am upgrading to PEI
by becega
Mon May 15, 2017 6:07 pm
Forum: Adhesion Surfaces
Topic: PEI and TPU?
Replies: 3
Views: 658

PEI and TPU?

For what i have been reading, TPU shoudl not be printed directly over PEI, or it will be impossible to remove. What is the recommended practice if I added PEI to my glass? Should i just flip it (the PEI would be in contact with the aluminium), and print on the glass? Buy a second Glass surface? Add ...
by becega
Mon May 08, 2017 12:32 am
Forum: Micro Extruder Assembly
Topic: Check your config file...
Replies: 5
Views: 1443

Re: Check your config file...

by becega
Fri May 05, 2017 4:49 pm
Forum: Calibration
Topic: What are usefull pre-print GCODEs?
Replies: 2
Views: 812

Re: What are usefull pre-print GCODEs?

G1 X0 Y85 Z100 F3000; Moves the head to the back of the printer rather than in the middle, this way if plastic drips while heating the hot end it doesn't fall in the middle of the print area.
by becega
Fri May 05, 2017 4:46 pm
Forum: Micro Extruder Assembly
Topic: Check your config file...
Replies: 5
Views: 1443

Re: Check your config file...

Which is the heat sink that is included in the heat sink? The BOM still has the active cooling fan.