Search found 4 matches
Search found 4 matches • Page 1 of 1
- Sat Oct 27, 2018 2:15 pm
- Forum: D300VS-PLUS
- Topic: Configs for Dual Material Cyclops+Aqua
- Replies: 4
- Views: 772
This is awesome. I bought my printer to specifically print stuff for cars (well my car) that if bought, would equal the cost of the printer. So it was a no brainer, make the stuff myself and have a toy. That said, do you have any settings for a .8mm nozzle? I've noticed that most of the car stuff I ...
- Tue Apr 24, 2018 10:27 am
- Forum: Electronics Wiring
- Topic: Extruder to Duet wiring
- Replies: 1
- Views: 396
I want to use the correct 4pin plug for the Duet from E3D motor, and was wondering what the pin order was for the Duet. Currently I have it as red blue green black going left to right.
Hope this helps, First, don't install/remove the tensioner block on the carriages like the initial directions state. They have to come off to make the belt install possible. Start with this, and pre-position the M2.5 Allen bolt on the carriage shown in the picture. https://i.imgur.com/MsQghUD.jpg Ne...